Abicor Binzel ABIDRIVE V2 Mode D'emploi page 51

TIG cold-wire feeder
6.5 Connecting the intermediate cable assembly
NOTICE
• Only use intermediate cable assemblies and torch cable assemblies designed for the ABIDRIVE V2.
• For information on connecting the intermediate cable assembly to the power source, please see the operating
instructions for the relevant power source.
1 2
14 13
1 Power source
2 Power source control lead connector
3 Power source gas connector
4 Intermediate cable assembly
5 ABIDRIVE control lead connector
Fig. 14 Connecting the intermediate cable assembly
1 Insert the power source control lead (5) into the ABIDRIVE connection bush (7) and secure it by turning the nut clockwise.
2 Insert the power source control lead connector (2) into the power source connection bush (1) and secure it by turning
the nut clockwise.
3 Insert the power cable for the power source (9) into the ABIDRIVE welding current connection bush (7) and secure it by
turning the nut clockwise.
4 Insert the power cable for the power source (12) into the welding current connection bush for the power source (1) and
secure it by turning the nut clockwise.
5 Connect the ABIDRIVE gas connector (6) to the ABIDRIVE connection bush (7).
6 Connect the gas connector power source (3) to the power source connection bush (1).
7 Connect the coolant supply and return hoses (8) and (10) to the ABIDRIVE connectors (7).
8 Connect the coolant supply and return hoses (13) and (14) to the power source connectors (1).
BAL.0415.0 • 2018-10-22
3 4 5
12 11 10
6 ABIDRIVE gas connector 11 Potential equalisation cable
7 ABIDRIVE V2 12 Welding current power source
8 Coolant return (red) 13 Coolant return (red)
9 ABIDRIVE welding current 14 Coolant supply (blue)
10 Coolant supply (blue)
6 Putting into operation
6 7
9 8
EN - 19