Front Panel - Abicor Binzel ABIDRIVE V2 Mode D'emploi

TIG cold-wire feeder

6.3 Front panel

1
9
8
1 Display for parameter indicator 4 Parameter time [sec]
2 Display for parameter value 5 Knob for setting parameters
3 Feed rate [m/min]
Fig. 5 Front panel display
Display indicators
Left display (1)
Indicator Description
SPE Wire feed rate
(0.2 – 8.0 m/min)
dt Wire feed delay time
(0 – 3 sec.)
re Wire retraction time (off – 3 sec.)
ton Wire feed with interval (0.1 – 5 sec.)
Only if function type (7) 'interval' has
been selected
tof Wire feed interval break
(0.1 – 5 sec.)
Only if function type (7) 'interval' has
been selected
run While welding with a wire feed
- - - During the break with an interval
Tab. 9 Display indicators after switching on
BAL.0415.0 • 2018-10-22
2
6
7
6 Parameter selection
7 Function type selection
Right display (2)
Indicator Description
Value between Indicator (3) (top) in m/min
0.2 and 8.0
Value between Indicator (4) (bottom) in seconds
0 and 3.0
Value between Indicator (4) (bottom) in seconds
Off and 3.0
Value between Indicator (4) (bottom) in seconds
0.1 and 5.0
Value between Indicator (4) (bottom) in seconds
0.1 and 5.0
6 Putting into operation
3
4
5
8 Wire feed
9 Wire retraction/function
button
EN - 11