probst RG-SAFELOCK Serie Instructions D'emploi page 54

Maintenance and care
7.2 Trouble shooting
Fault
The product slips
The device is crooked
SAFELOCK-Mechank does not
work / not correctly
54500008
Cause
Gripper jaws/gripper claws are
•
worn out
The load capacity is greater than
•
permissible
→ see chapter "Authorised use"
for vitrified clay pipes
The wrong gripping range is set
•
• The height support is set
incorrectly
• The surface of the load is dirty
The product is not suitable /
•
permitted for this device
• The device is loaded on one
side
The gripping range is not
•
symmetrically adjusted
The height support is not set
•
symmetrically
• Foreign bodies in the mechanics
Dust or dirt in the mechanics
•
• Leg spring not hooked in
• leg spring bent / broken
21 / 24
Remedy
Change gripper jaws/gripper
•
claws
Reduce load capacity
•
Adjust the gripping range to the
•
outer diameter of the product
• Adjust the height support
according to the products to be
transported
• Clean the surface of the product
from dirt
Consult the manufacturer to
•
determine whether the product is
permitted for this device
• Focus on the product
Check and correct adjustment of
•
the gripping range
Check and correct the height
•
support setting
Check for possible foreign
•
bodies in the internal gearing
and remove them
Clean the mechanics with high
•
pressure cleaner
• Hook in leg spring (e.g. with
pliers or screwdriver)
• Replace leg spring (consult
manufacturer if necessary)
GB