CF MOTO ZFORCE 800 Trail Guide Du Propriétaire page 175

9� During filling coolant, unscrew the coolant drain bolt to release residual air inside the coolant hose until
only fluid flows out, then screw back in and tighten the drain bolt.
Drain Bolt Torque: 7.4 ft-lb. ( 1 0 N·m )
10� Install radiator cap after full filling the coolant.
11� Start the engine and idle for several minutes until the cooling fan turns on, then turn off the engine.
12� Inspect the coolant level after engine cool-down. Add additional coolant into the top of radiator if coolant
level is low�
13� Fill coolant into reservoir until the level is between the upper and lower mark.
14� Install coolant reservoir cap�
15� Start the engine and idle for several minutes to inspect for leaks, contact your dealer to inspect the
cooling system if any leaks are found.
16� Install front access cover.
17� Dispose the used coolant in a proper way�
Maintenance
175