Christopeit Sport TM800S Notice De Montage Et D'utilisation page 21

Pulse measurement unction
Embrace with both hands, the hand pulse sensors on the computer to
order a pulse measurement can be perormed. Alternatively use a compa-
tible chest belt (un -coded with transmission
requency rom 5.0-5,5kHz). The measured pulse value appear in the pulse
display. Caution: The pulse measurement is not suitable or medical pur-
poses.
Function o saety clip
The saety clip has an emergency unction. In ear or danger or i you all
down or jumped rom it, the saety clip will lose position at computer and
stops the motor with break system. Put the saety key out rom computer
on any status, the display is „---", the buzzer beep each second. Put the
saety key on computer, then the display will enter normal manual mode.
All parameter reset to zero.
Meanings o error message codes
In case o malunctions may adjoining list o error messages help or peo-
ple to get unction back. Basically, electrical repairs only in compliance
with the relevant saety rules which exists. For more inormation and assi-
stance in case o malunctions with our service department (contact details
see last page.)
Problem Potential reasons
---- Sae lock alls down
E01 Communication error
E02 Motor cable
Improperly connected
E03 Speed signal error
E05 Overload Protection
E06 Undervoltage protection
Training area in mm
(or home trainer and user)
Hibernation
I the treadmill stays in standby model or more than 10 mins, it will hiber-
nate.
Km / Miles – Switching
I you remove the saety clip and press the
neously or 3 seconds, you will hear a beep and the screen will display the
maximum speed or both units (16 or km/h or 10 or m/h).
Solutions
Place back the sae lock.
Check to see i communication cable properly connected or damaged
Check to see i motor cable properly connected.
Check i the controller smells peculiar, i so replace the controller.
Check i speed sensor properly connected, reconnect i necessary.
Check i speed sensor properly xed or damaged, re-x or replace i
necessary.
Check i motor is damaged and replace accordingly.
Overload or treadmill jam will result in an overload protection. Check i
motor running with an overload sound or burnt smell and replace the
motor or controller.
Check i rated voltage is in accordance with the treadmill and use the
correct rated voltage to power the treadmill
Check i there is a low voltage lower than 50% o normal voltage. I so
please operate in a higher voltage environment.
Check i controller smells peculiar, i so replace the controller
Free area in mm
(Training area and security area
(rotating 60cm))
21
and buttons simulta-