Christopeit Sport TM800S Notice De Montage Et D'utilisation page 18

Maintenance and adjusting
1. Lubrication or the running belt:
In order to keep the machine in the best condition, please add
some Silicone oil between the running belt and the running board
ater 50 hours or 1 to 2 month o use. But the running belt may
slip, i you lubricate too much. To lubricate the belt please pull
the walking belt up and injection the silicone oil into the gap
between belt and walking deck.
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per
the ollowing steps i it is o.
1. Set speed at 3-5km.
2. Using the Allen key to adjust the belt tension bolt on the end
cap o the system rame.
3. I you want to move the belt towards let, turn the right tension
bolt clockwise.
4. I you want to move the belt towards right, turn the let tension
bolt clockwise.
5. I you have already done according to the steps above and
it is still not at the good range, then the running belt should be
damaged already, please contact your local dealer or replace-
ment.
Note: Make sure that the running surace is as centered as possible. Once
these moves too ar rom the center, (about 10 mm) it should be readjusted
into the center.
3. Running belt slips:
1. Make sure the walking belt is not too loose.
2. Make sure the motor belt is not too loose.
4. No light on the Display:
1. Check i the power plug is properly connected.
2. Check i the saety key on the computer is in place.
3. Check i the wire in the right post is properly connected.
Remind ! Beore you inspect any wire or electrician part, ple-
ase ensure that the Power supply has been turned o.
5. Abnormal noise rom the machine
1. Check i any screw o machine is loose.
2. Check i the motor belt is o.
3. Check i the running belt is o.
Note:
Please contact your local dealer i you have checked all the
above listed things but the problem is still there.
18