English
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be restricted.
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
21.7
Sound values and vibration val‐
ues
STIHL recommends wearing ear defenders.
– Sound pressure level L
to EN ISO 22868: 83 dB(A) The K value for
the sound pressure level is 2 dB(A).
– Sound power level L
EN ISO 22868: 94 dB(A) K-value (uncertainty)
for sound power level is 2 dB(A).
– Vibration level a
measured according to EN
hv
ISO 22867
– Control handle: 2.2 m/s². The K value for
the vibration level is 2 m/s².
22 Bar and Chain Combinations
22.1
STIHL MSA 161 T Cordless Chainsaw
Pitch
Drive link
gauge/groove
width
1/4" P
1.1 mm
The cutting length of a guide bar depends on the chainsaw and the saw chain being used. The actual
cutting length of a guide bar may be less than the specified length.
23 Spare Parts and Accesso‐
ries
23.1
Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.
50
measured according
pA
measured according to
wA
Length
Guide bar
25 cm
Rolloma‐
tic Light 01
30 cm
22 Bar and Chain Combinations
– Handlebar: 2.1 m/s². The K value for the
vibration level is 2 m/s².
The sound and vibration levels indicated were
measured according to a standardized test
method and can be used as a basis for compar‐
ing electric power tools. The actual sound and
vibration levels may vary from the values indica‐
ted, depending on the type of application. The
sound and vibration levels indicated can be used
for an initial estimate of the sound and vibration
stress. The actual sound and vibration stress has
to be estimated. The times can be taken into
account in the estimate when the electric power
tool is switched off and also when it is switched
on but running without any load.
21.8
REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
Number of
Number of
teeth, spro‐
drive links
cket nose
8
24 Disposal
24.1
Disposing of Chainsaw and
Battery
Contact the local authorities or your STIHL
dealer for information on disposal.
Improper disposal can be harmful to health and
pollute the environment.
► Take STIHL products including packaging to a
suitable collection point for recycling in accord‐
ance with local regulations.
► Do not dispose with domestic waste.
25 EC Declaration of Con‐
formity
25.1
STIHL MSA 161 T Cordless
Chainsaw
ANDREAS STIHL AG & Co. KG
Saw chain
57
71 PM3 (type
3670)
65
0458-791-9621-D