Publicité
Les langues disponibles
Les langues disponibles
Problem
Possible Cause
Solution
Won't
Water inlet valve
Clean screens.
Fill/Won't
screens are plugged.
Rinse/Won't
Agitate/
Water is turned off.
Turn on water.
Wrong
Hot and cold hoses are
Reverse hoses (see "Installation
Temperature/
reversed.
Instructions," Sections D & E).
Shortened
Cycle
Inlet hose is kinked.
Straighten hoses.
Power cord not plugged in.
Plug in power cord.
Oversudsing detected.
Do not start with excess water in the
machine. Drain/Spin load; restart cycle.
Do not add detergent.
Machine
Power cord not plugged in.
Plug in power cord.
Stops
No power at plug.
Check electrical source or call
electrician.
Fuse blown or circuit
Replace fuse or reset circuit breaker.
breaker open.
If problem continues, call electrician.
Using an extension cord.
Do not use extension cords.
STOP/CANCEL pad was
Set a new wash cycle and press
pressed.
START pad.
DELAY START pad was pressed. Press START pad to restart washer.
If console light is off, set a new wash
cycle, then press START pad.
Washer at pause in
Allow cycle to continue
PERMANENT PRESS Cycle
(see "Operating Your Washer").
(approximately two minutes).
Machine is overloaded.
Wash smaller loads.
Agitator Not
The top of the agitator moves
This is normal.
Working
only in one direction.
The top of the agitator is loose.
This is normal.
Water Level
The top of the agitator is much
This is normal.
Too Low/Not
higher than the highest water
Completely
level. This creates a perception
Filling
of the washer not being full.
Tub is
Tub pulled forward when
Ensure tub is centered before
Crooked
unloading,
starting washer.
Tub moves.
This is normal,
Unit not level,
Ensure front feet are installed and
nuts are tightened. Level washer.
Reset rear legs (see "Installation
Instructions," Section G).
44
Publicité
