Kenmore ELITE SENSOR SMART Mode D'emploi page 29

STEP 3. Select thedesired
WATER L EVEL a nd WASH/RINSE
TEMP
STEP 4.Select 10to60minutes ofsoak
time withthe AGITATION TIME pad.
STEP 5.Press S TART.
The washer agitates briefly a nd then
soaks. A fter s oaking, thewasher
agitates again followed bydrain and
spin, S OAK Only should b efollowed by
a wash cycle with additional detergent
added.
RINSE O PTIONS
Selecting thisoption
allows y outochoose
a
DRAIN/SPIN,
RINSE/SPIN or
2ND RINSE
DRAIN/ SFIN
RINSEI SFIN
2ND RINSE
To select a Rinse Options setting:
Press RINSE OPTIONS until the
indicator light next to the desired setting
glows
DRAIN/SPIN
Use this cycle to drain the washer and
spin the load, The spin will be 6 minutes
at high speed.
When to use Drain/Spin:
• To drain the washer after canceling
a cycle.
• To complete a cycle after the power has
been off.
• To shorten drying times for some
heaw fabrics,
• To remove water from rain wear or
beach towels, etc.
To use Drain/Spin:
STEP 1, Press DRAIN/SPIN
STEP 2. Press START
RINSE/SPIN
Use this option to get a deep rinse with
slow-speed agitation followed by a drain
and two-step spin (The spin begins at
high speed and steps down to low
speed,) The time display will include an
estimate of how long it will take to fill and
drain the washer
When to use Rinse/Spin:
• For loads that need rinsing only
• When using extra detergent with
a load
• For completing a cycle after the
power has been off
• To add fabric softener to clothes
To use or change Rinse/Spin
settings:
STEP 1. Add fabric softener to
the dispenser (if desired)
STEP 2, Press the RINSE OPTIONS
Control until the RINSE/SPIN indicator
light glows
STEP 3. Press START
2ND RINSE
Selecting this option provides a second
deep rinse with the same water
temperature as selected for the first
rinse. 2ND Rinse can be added to any
main wash cycle.
CHOOSING MODIFIERS
These controls allow you to select the
desired WATER LEVEL, WASH/RINSE
TEMP, AGITATION TIME, DELAY START
or END OF CYCLE SIGNAL.
WATER LEVEL CONTROL
This control gives you the flexibility
to save water when washing small
loads,
o L_U_E
(ND
Your washer lets you select a water
level setting based on the size of your
wash load.
• Adjust water level up or down
depending on your load size. Clothes
should move freely and roll toward
the agitator.
• To change to a higher water level
setting after the washer has started
to agitate, press WATER LEVEL.
NOTE: When you select a water
level below medium, the washer
automatically lowers the agitation
speed in order to provide improved
fabric care, This change occurs in
every cycle except HANDWASH
CASUAL and ULTRA HANDWASH.
29