Kenmore ELITE SENSOR SMART Mode D'emploi page 32

DELAY START INDICATOR LIGHTS
i-lu-vum.- "-I=.] i[:417[,
You can use the Delay Start feature to
delay the start of a wash cycle.
STEP 1. Load the washer and fill the
dispensers.
STEP 2. Close the washer lid.
STEP 3. Select the desired cycle, options
and modifiers.
STEP 4. Press DELAY STAR£ 1H (one
hour) will be displayed in the time display
window. The indicator light for DELAY
TIME will glow.
STEP 5. For a longer delay time, press
DELAY START, The time will increase
by one hour up to 9, 10, or 11 hours
(depending on your model).
STEP 6. Press START, The countdown
to the wash cycle will show in the time
display window,
To change the Delay Time:
• Press STOP/CANCEL
• Reset the DELAY START time.
• Press START to begin the countdown.
To cancel Delay Start:
Press START again to begin cycle.
ADJUSTABLE CYCLE SIGNAL
A tone will sound at the end of the wash
cycle, The sound level of this tone can be
adjusted from Loud to Off by pressing the
END OF CYCLE SIGNAL. The tone you
will hear at the end of the cycle will sound
as the pads are pressed.
m LOUD
I
QUIET
I
OFF
SELECT CYCLE
Located next to each pad, these lights
show the cycle you have selected.
OPTIONS
Located next to each pad, these lights
show the Options you have selected.
MODIFIERS
These lights show the selected Water
Level, Wash/Rinse Temp or ATC,
Estimated Time Remaining, Agitation
Time, Delay Time, Washer Status and
Signal.
WASHER STATUS
These lights show which portion of the
cycle the washer is operating: Washing,
Rinsing, Spinning, or Cycle Complete.
OPERATING CONTROLS
START
Press START to start your washer after
a cycle has been selected, Be sure all
desired cycle adjustments and options
have been selected.
STOP/CANCEL
Press STOP/CANCEL to pause or stop
the washer at any time.
Press START to complete the cycle from
where it was stopped. Press STOP/
CANCEL twice to turn off the washer.
@