Publicité
Les langues disponibles
Les langues disponibles
[}W TO INSTALL
AN[}
(SELECT MODELS)
iiiiiiiiiiii_i!_!i!!i!!i!!i_!_!!_!!_I_!_i!_i_i_!_i_i_i_i_i!_!_i!_!_!i_i_i_i_i_i
¸_!iii!_
_i_!!_!!_!!_!!_!_!_!_!_!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_!!_
!i!i!i
!i!i!i!i!i
!i!i!i
!i!i!i!i!i
!i!i!i
!i!i!i!i!i
!i_ _ i i_!!ii !i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!i_!
i_!i_!i_
!i_!i_!i_!i_!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!ii!ii!ii!ii!ii!ii!ii!ii
!iii!_!i!i!
NOTE:
> To protect door surfaces from being
scratched, cover back edges of
decorator panels by placing masking
tape along back edges.
> Save all screws and reuse in original
locations.
¼" (6 mm) Panel Dimensions
Extended
Door
Panel
Fresh food
door
Upper
dispensing
freezer door
Lower
dispensing
freezer door
Non-
dispensing
freezerdoor
Panel
Panel
Height
Width
66 _"
18 15_611
(169.5 ore)
(48.1 ore)
18 1/8"
13 15_6"
(46 ore)
(35.4 ore)
32 _3_"
13 15_6"
(81.5 ore)
(35.4 ore)
66 _4"
13 15_6"
(169.5 ore)
(35.4 ore)
INSTALLING PANELS
1. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
,
,
,
,
,
Slide handle upward until
loose. Remove handle
from door.
Remove door
retainer clips with
a ¼" hex head
driver.
Slide bottom of panels into bottom
door trim until hinge side of decorator
panel rests under hinge side trim.
IMPORTANT: Tape tops of panels to
door to prevent panels from falling.
Reinstall door
retainer clips with
a ¼" hex head
driver.
Reinstall handle by inserting retaining
clips on door into notches on back of
handle.
> Slide handle down until it contacts
bottom trim.
7. Remove tape from
tops of panels
before reinstalling
top door trim with
Phillips screws
removed in step 1.
REMOVING PANELS
1. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
IMPORTANT: Tape tops of panels to
door to prevent panels from falling.
t t
,
,
,
,
Slide handle upward until 4_1
"_
loose. Remove handle
from door.
Remove door
retainer clips with
a V_"hex head
driver.
Remove tape to slide panels out of
door trim.
Refer to steps 5, 6 and 7 of
Installing Panels to install handles
and trim.
Publicité
