Publicité
Les langues disponibles
Les langues disponibles
]4
SPILLSAVER
TM
(SELECT MODELS)
Spillsaver
TM
Stationary
Shelves hold simple
spills for easier cleaning.
> To remove shelves, lift up and out.
> To install shelves, reverse above
procedure.
tr_
Some models feature
the Spillsaver
TM
_
EasyGlide'M
_il_'_._
Shelves.
Be" "'-'_
EasyGlideTM
_,_llj
shelves feature the convenience of easy
cleaning with a pullout design to reach
items in the back. For ease of cleaning,
glass shelf may be removed by pulling to
full extension and lifting out of frame.
> To remove shelf and frame, see
above instructions for Spillsaver
TM.
REAR SHELF
EXTENSIONS
(SELECT MODELS)
Rear Shelf Extensions help prevent
articles from falling off the back of the
shelf.
To remove and install shelf extension:
> To
remove,
pull extension
straight
up
from rear of
shelf.
> To install, insert posts of the shelf
extension into holes in the shelf frame.
SIDEGLIDE
TM
SHELVES
(SELECT MODELS)
SideGlide
TM
Shelves hook onto a rear
double-crossbar assembly, Shelves may
be aligned side by side to create a full
width level surface, or if attached to
separate crossbars, the shelves may
slide left or right to accommodate
storage needs.
To remove and install shelf:
> To remove shelf,
raise shelf 10° to
unhook from
double crossbar
and lift out.
> To install, reverse
above procedure.
To slide shelves:
> Lift front of shelf
slightly and slide
left or right.
To remove and
install double-
crossbar assembly:
> To remove, slide
assembly up to
unhook from metal
track.
> To install, reverse
above procedure.
)OR S[O E
BEVERAGE CHILLERTM/
MINI CHILLER
TM
(SELECT MODELS)
The temperature-controlled Beverage
Chiller
TM
keeps beverages and other
items colder than the rest of the fresh
food section. Air inlet allows air from the
freezer section to pass to Beverage
Chiller
TM.
Controls
The Beverage Chiller
TM
control is
located on the left wall of fresh food
section. Control adjusts amount of air
circulating in Beverage Chiller
TM.
Turn
control clockwise for colder temperature.
To remove and install Beverage
ChillerTM:
> If located directly above Beverage
Chiller
TM,
dairy center or door bucket
may need to be removed. Refer to
appropriate instructions and remove
item. Slide Beverage Chiller
TM
assembly up and pull straight out.
> To install, align
_::_;_z_l IlII1 I/
one of the
"_ ,,_ _'_,_III,,
Beverage
/iv" __
Chiller
TM
cold -4_:___=al
IIIlt
air intake
_ _]_'_IHI I
holes (A) with
_
_" I Illll
one of the two
air inlets (B) in door liner. Push
assembly down onto door liner
retainer until it stops.
IMPORTANT: Beverage Chiller
TM
will
not operate properly if air intake holes
are not aligned with air inlet in door liner.
Publicité
