Maytag Amana Manuel Du Propriétaire page 18

iCE STORAGE BiN
The ice Storage
Bin is located below
the automatic
dispensing ice
maker.
To remove and
install ice storage bin:
> To remove bin, remove the Quick
Chill Zone
TM.
> Raise ice maker arm to deactivate ice
maker. Lift front of bin and pull out to
its full extension. Lift up front of bin
and remove.
> To install, slide bin into rails below ice
maker until bin locks into place. Drop
ice maker arm to activate ice maker,
and replace Quick Chill Zone
TM.
IMPORTANT: 5 (_
Ice bin must be
locked in proper
place for proper
ice dispensing. If freezer door does not
close, bin is not in proper location. Turn
auger driver counterclockwise (as
shown) to properly align ice bin with
back of refrigerator.
}OR STORAGE
ADJUSTABLE DOOR
BUCKETS
Door Buckets adjust to meet individual
storage needs.
To remove buckets:
> Lift the door bucket up until
it clears the retainers on the
door liner, then pull the
door bucket
straight out.
To reinstall buckets:
> Slide bucket in above desired door
liner retainer and push down until
bucket stops.
FIXED DOOR BUCKET
(SELECT MODELS)
The Fixed Door
Bucket is locatedin the
upper section of the
freezer door.
IMPORTANT: Fixed
door bucket is not
adjustable. If bucket is removed, freezer
light will not deactivate when door is
closed.
TILT-OUT DOOR BUCKETS
(SELECT MODELS)
The Tilt-Out Bucket assembly consists
of a bucket and frame, providing
adjustable, convenient storage for food
items in door. The bucket assembly tilts
forward for easy access of items, and lifts
out for ease in cleaning and adjusting.
To remove and
install bucket:
> To remove, tip
bucket forward
and pull straight
out to remove.
\
\
To
To install bucket, slide bucket into
bucket frame and push bucket
upright.
adjust bucket frame:
Remove bucket per above
instructions.
> Lift frame off
door support
and place in
desired door
location.