Maytag Amana Manuel Du Propriétaire page 7

Some installations require door removal
to get refrigerator to final location.
1. Remove toe grille and bottom hinge
covers.
> Open both doors 180 degrees, or
as wide as possible to remove.
2. While pinching white collar (A) to the
blue connector (B), pull water line
from connector.
IMPORTANT: When reconnecting water
line, cut off tubing at first available
scored line before inserting into
connector collar.
3. Remove top hinge cover by removing
Phillips screw.
4. Close doors.
5. Unscrew %6"hex head screws from
top hinges.
For dispensing models only:
> DO NOT remove either green
ground wire or wire connecting
center screw.
,
For dispensing models only:
Detach main wire connector harness
and red wire harness.
> To detach main wire harness, use
a flat blade screwdriver or finger-
nail to press junction point
between two connectors to
release.
> To detach red wire harness, press
tab on underside of connector to
release.
7. Remove top hinges along with doors.
,
Remove bottom hinges with a 78"hex
head driver.
.A(ING THE # {}ORS
> To replace the doors, follow the steps
in Removing the Doors and Hinges
in reverse order.
IMPORTANT: When reconnecting water
line, cut off tubing at first available
scored line before inserting into
connector collar.
t