Télécharger Imprimer la page

Angelcare AC403 Manuel De L'utilisateur page 95

Masquer les pouces Voir aussi pour AC403:

Publicité

Les langues disponibles

Les langues disponibles

15.19 Power Lines - An outside antenna
system should NOT be located in the
vicinity of overhead power lines or other
electric light or power circuit, or where it
can fall into such power lines or circuits as
contact with them may be fatal.
15.20 WARNING Strangulation Hazard —
Children have STRANGLED in cords. Keep
adapter cords out of the
reach of children (more
than 1 m away). NEVER
u s e
without the protective
cord covering. Check
p r o t e c t i v e
covering before each
use. Immediately discontinue use of Sensor
Pad(s) if protective covering is damaged
or broken.
15.21 Interference - This monitor uses public
airwaves to transmit signals. The Parent
Unit may pick up signals or interference
from other nursery monitors in your area.
Your monitor may even be picked up by
other households. To protect your privacy,
make sure both units are turned OFF when
not in use. If you experience interference,
change the channel on both units.
15.22 Vibration Source - When the monitor
is in use, DO NOT use a crib mobile or
other crib accessories that may produce
vibrations. Other sources of vibrations
may include fans, washing machines, loud
music, etc. These sources of vibration may
interfere with the performance of your
Angelcare
monitor and the alarm will
®
not sound if it continues to detect any
movement other than your baby's. Be sure
all vibration sources are eliminated before
using the monitor.
You may experience false alarms for several
reasons. The most common reason is the
Nursery Unit has not been turned OFF after
you have removed your baby from the crib.
Another reason is the Sensor Pad has not
been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm
surface with the printed side facing up.
The sensitivity level may also need to be
adjusted. Refer to step 5.3. Always be sure
to immediately check on baby whenever
an alarm sounds.
15.23 Sensor Pad - If the crib has a
spring or slat base, place a hard board
between the crib base and the Sensor Pad
measuring at least 33 x 33 cm and 6 mm
thick. Only use your Angelcare
a stationary sleeping environment such as
All manuals and user guides at all-guides.com
a crib where the Sensor Pad can rest on a
completely flat, firm surface.
The sensor pad is made of plastic and does
not permit the air to circulate. Therefore,
mildew build up could develop underneath
the mattress in the sensor pad area. We
suggest rotating the mattress regularly to
prevent any mildew.
16. IMPORTANT SAFETY INSTRUCTIONS
RELATED TO USE OF BATTERIES
S e n s o r
P a d (s)
16.1 Use ON LY the t ype and size of
batteries specified in the owner's manual.
There is a risk of explosion if batteries are
c o r d
replaced with an incorrect type.
16.2 U s e
batteries and/or the AC Adapters provided
for the Parent Unit. You must use only
rechargeable batteries in the Parent Unit.
DO NOT use alkaline batteries or you will
severely damage the unit.
16.3 Charge the batteries for 15 hours prior
to first use. Be sure to have the monitor in
the OFF position during this period. ONLY
use the AC Adapters included with your
monitor.
16.4 DO NOT use these adapters with any
other equipments.
16.5 When unplugging the AC Adapter
from the Nursery Unit, be sure it is switched
to the OFF position. If it isn't, the unit
will revert to battery mode if batteries
are installed.
16.6 DO NOT use rechargeable batteries
in the Nurser y Unit. Use ONLY non-
rechargeable alkaline batteries of a decent
brand.
16.7 DO NOT dispose batteries in fire. They
may explode. Check with local regulations
for possible special disposal instructions.
16.8 Exercise care in handling batteries
in order not to short out the batteries
with conducting materials such as rings,
bracelets and keys. Overcharging, short
circuiting, reverse charging, mutilation, or
incineration of batteries must be avoided
to prevent one or more of the following
occurrences: release of toxic materials,
release of hydrogen and/or oxygen gas,
rise in surface temperature.
16.9 DO NOT attempt to recharge batteries
provided with or identified for use with
this product that are not intended to be
monitor in
®
charged. The batteries may leak corrosive
electrolyte or explode.
O N LY
A A A
r e c h a r g e a b l e
E
N
95

Publicité

loading