Publicité
Les langues disponibles
Les langues disponibles
FALSE ALARMS
• Verify the connection between Sensor Pad and Nursery Unit and if both Sensor Pads are
firmly "Click" connected. Unplug and reconnect the cord.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and
the Sensor Pad measuring at least 33 cm x 33 cm and 6 mm thick.
• Make sure the Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to step 5.3.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is ON.
• Place the crib near a solid supporting wall to avoid Sensor Pad from detecting
movement from outside the crib.
• You may need to increase the sensitivity, refer to step 5.3.
NO SOUND IS BEING TRANSMITTED
• Ensure that both units are switched ON.
• Check that the sound has not been turned down on the Parent Unit. Increase
the volume level on the Parent Unit, refer to step 5.5.
• Check on the Parent Unit screen to see if the monitor is in temporary MUTE mode
instead of ON mode. Deactivate the temporary MUTE function, refer to step 5.6.
• If there is no power to any unit check/replace the batteries, recharge the Parent Unit
& check the AC Adaptors are working. Change electrical outlets if required.
• Bring the Parent Unit and Nursery Unit closer together.
NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Turn the switch behind the left wing ON.
• Check connections or change to another electrical outlet.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Replace the batteries or recharge Parent Unit.
STATIC, DISTORTION, INTERFERENCES
(FROM OTHER MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)
• Rotate the Parent Unit or move it away from source of interference.
• Try a different channel, refer to Step 4.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move the units farther apart (at least 3 meters apart).
• Decrease the volume on the Parent Unit.
THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)
• Turn the Parent Unit back ON by pushing and holding the power button.
• Replace the batteries or recharge the Parent Unit.
116
All manuals and user guides at all-guides.com
Publicité
