Publicité
Les langues disponibles
Les langues disponibles
STEP 4 - TURNING ON YOUR MONITOR
1
When the Parent Unit is turned
ON and the Nursery Unit is OFF:
• No channel icon will appear
• After 1 minute the Parent Unit
CHANNEL SELECTION
1
3
104
All manuals and user guides at all-guides.com
2
on the screen but the Nursery
Unit icon will blink.
will start to beep. The Parent
Unit will continue to beep
for 5 seconds and then shut
itself off.
2
1) Press the Parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit Power
ON/OFF button.
NOTE:
The screen of the Parent Unit will show
the channel of transmission (C1 to C8) and
after 5 seconds the room temperature and
function icons.
The connecting process should be done
within 30 seconds. If this sequence is not
completed within 30 seconds you will need
to switch the units off and start again.
If there is a lost connection
between the 2 units
(refer to troubleshooting):
• The Out-of-range icon
(if activated) will blink
on the screen and the Parent
Unit will beep.
TO SELECT THE CHANNEL:
1) Press and hold the select button
to enter the channel mode.
2) Pressing either the UP or DOWN arrow
will change the channel your monitor
transmits on. (C1 to C8)
3) Press the select button again
to confirm your channel selection.
NOTE :
If the transmission is not clear, or if you hear
interference sounds, you should change
the channel.
Publicité
