Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• (With Parent Unit switched off) Ensure that you fully charge your batteries for 15 hours
before their first use.
• To maintain maximum battery life it is recommended that you fully discharge
your batteries periodically. Battery performance can be diminished by leaving
the batteries constantly charging. If your parent unit is not in use, please turn it off.
• Inadequate battery power can impair the performance of your monitor. If you are not
happy with the performance of your Parent Unit/Monitor please replace the
rechargeable batteries (3 or 6 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months.
LOSS OF CONNECTIVITY
In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery Unit
closer together and make sure that both units are ON to restore the connection. If there is
still no connection and no out of range warning after the above has been done, then and
only then should the re-connection procedure below be done.
Re-connection procedure:
1
2
4
All manuals and user guides at all-guides.com
1) Turn OFF the Parent Unit and switch it
3
2) By pressing and holding for 3 seconds
3) To set the Nursery Unit in to connectivity
4) When the Parent Unit and Nursery
back ON. LCD will only show '——' with
back light on and nursery unit icon
will flash.
the Parent Unit "MENU/CONNECT"
button, the Parent Unit will be set in
to connectivity mode (you will hear a
beep tone and the antenna icon will flash
for 15 seconds).
mode, press and hold the Page button
for 4 seconds (on the back of the
Nursery Unit). The Power LED will light
and a beep tone will be emitted as
the connection procedure should
be completed.
NOTE:
If step 3 is not followed within the duration,
the Parent Unit will exit the connectivity
mode and you will need to start this
process again.
Unit are connected, the parent unit
emits a confirmation tone and will
show the channel number which will be
replaced by the temperature (normal
screen) a few seconds later.
NOTE:
If the TIC light is flashing, do not
press the "Page" button or the link may
be interrupted.
E
N
115
Publicité
