Publicité
Les langues disponibles
Les langues disponibles
5.3 - CHANGING THE MOVEMENT AND SOUND MONITORING FUNCTIONS
TO SET DETECTION MODE:
1
2
Movement Only
Sound Only
'TIC', Sound & Movement
Sound & Movement
'TIC' & Movement
TO TEST THE SENSOR PAD:
MOVEMENT OR "TIC" MODE NEED TO BE ACTIVATED:
1
2
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear a single 'TIC' pre-alarm sound from
the Nursery Unit.
• If after a further 5 seconds there is still NO movement detected both the Parent Unit and Nursery
Unit speakers will emit loud warning sound.
• Nursery Unit icon flashes on the Parent Unit
• Green light on the Nursery Unit will turn off to indicate NO movement is being detected.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation, or leave the room in case
of a wooden floor.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
All manuals and user guides at all-guides.com
1) Press briefly the MENU button once and
3
2) Use the UP and DOWN Arrows to select
3) Press the SELECT button to confirm
4) Press the MENU to view the next option,
NOTE:
If you press the MENU button for too long
the unit will go in to connection mode and the
Out-of-Range indicator will start flashing. If this
happens, wait 20 seconds and then press
the MENU to start again.
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress.
3) Repeat by moving your hand lightly
the flashing icons will appear.
your preferred detection mode.
your choice.
or EXIT if you wish to stop programming.
Pendulum icon will appear
on Parent Unit indicator bar.
It will move as you move your
hand and trigger a 'TIC' sound.
After 15 seconds you will hear a
'TIC' pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
in all four corners of the mattress.
Ensure the Nursery Unit Movement
Indicator is still flashing.
E
N
107
Publicité
