Publicité
Les langues disponibles
Les langues disponibles
2.2 SELECT THE CRIB LEG YOU WILL BE USING TO SECURE THE CORD COVERS
RECOMMENDED
6
5
Fig 1
OR
6
4
3
2
1
Fig 2
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
3
5
6
4
5
All manuals and user guides at all-guides.com
4
3
2
1
5
1) Remove the mattress from the crib.
4
2) Place the Sensor Pad - printed side up
3
2
3) Run the connection pin, warning label
1
4) Bring the first 4 cord covers down
5) Remove any cord slack to make sure
5
1) Use the crib leg by the wall closest to
the Nursery unit (Fig 1). In cases where
the Nursery Unit is across the room, use
the leg closest to the Nursery Unit to
position the covered wire (Fig 2). It is
always preferable that the covered cord
run along a wall.
- on top of the hardboard at the center
of the crib.
and the first 5 cord covers down along
the backside's of the crib leg, between
the mattress support and the inside
edge of the crib.
the floor, and keep the 5
vertically, along the backside of the crib
leg, (between the mattress and the
inside edge of the crib).
no parts of the cord are loose.
E
N
cord cover
th
101
Publicité
