Publicité
Les langues disponibles
Les langues disponibles
V 3.0
1/4 in. Composite Angled Air Die Grinder
b.
Discontinue use if a hissing can be heard from the air
line or connectors while operating the tool.
c.
Take the following steps if either of the above situations
occur:
i.
ii.
3. Prevent damage to air hose by observing the following:
a.
Never use the hose to carry the tool.
b.
Keep the air hose of the tool and the tool's work path
while in operation. The hose should always stay behind
the tool.
c.
Keep the hose away from heat, oil, sharp edges or
moving parts.
d.
Do not allow people, mobile equipment or vehicles to
pass over unprotected air hose.
i.
ii.
iii.
e.
Do not wrap hose around the tool as sharp edges may
pierce the hose or cause cracks if wound too tight.
Gently coil the hose and either hang on a hook or fasten
with a device to keep hose together when storing.
4. An air hose under pressure that is damaged or disconnected
from an air tool may whip around and cause damage to the
work area or personal injury. Secure the compressor's air
hose to a fixed or permanent structure with clamps or cable
ties.
8
All manuals and user guides at all-guides.com
Tag or mark the tool as "defective" or "out of
service" until repaired.
Contact a qualified person repair or replace the
defective component/hose.
Position air hose away from traffic areas.
Place hose in reinforced conduit.
Place planks on either side of the hose to create a
protective trench.
For technical questions call 1-800-665-8685
8348690
Publicité
