PRO-POINT 8348690 Mode D'emploi page 15

8348690 1/4 in. Composite Angled Air Die Grinder
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will prevent unnecessary problems.
2. Keep the tool handles clean, dry and free from oil/grease at
all times.
3. Follow instructions for lubricating and changing accessories.
4. Inspect the tool fittings periodically. Have damaged or
worn components repaired or replaced by an authorized
technician.
5. Inspect the tool fittings, alignment and hoses and power
supply cord and components periodically. Have damaged
or worn components repaired or replaced by an authorized
technician.
6. Maintain the tool's label and name plate. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
WARNING! Disconnect the grinder from air supply before
changing accessories, servicing or performing maintenance.
Replace or repair damaged parts.
7. Check for damaged parts. Before using any tool, any part
that appears to be damaged should be carefully checked
to determine that it will operate properly and perform its
intended functions. Check for alignment and binding of
moving parts, for broken parts or mounting fixtures, or for
any other condition that may affect proper operation. Any
part that is damaged should be repaired or replaced by a
qualified technician.
a. Check tool speed regularly with a tachometer. If tool
is operating at a higher speed than the RPM marked
on the tool, the tool should be serviced to correct the
cause before use.
8. When servicing, use only identical replacement parts. Only
use accessories intended for use with this tool. Replace
damaged parts immediately. Non-authorised parts may be
dangerous.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
V 3.0
15