PRO-POINT 8348690 Mode D'emploi page 16

V 3.0 1/4 in. Composite Angled Air Die Grinder
9. Keep the tool clean. Wipe the tool with a clean cloth and
periodically blow out all areas with compressed air. If
compressed air is not available, use a brush to remove dust
from all areas. Do not use harsh chemicals or solvents to
clean the tool. Be sure to switch power OFF and disconnect
the air source during maintenance and inspection.
a. Some silencers on air tools may clog with use. Clean and
replace as required.
10. Regularly inspect all mountings and screws to ensure
tightness. Should any screws become loose, tighten
immediately.
11. If repairs are required, bring your tool to an authorized
service center.
12. All pro.point air motors should be lubricated. (see
Lubrication section)
CAUTION! Only qualified service personnel should repair the tool.
LUBRICATION
Only use the lubricants supplied with the tool or specified by
the manufacturer. Other lubricants may not be suitable and may
damage the tool or cause a malfunction during use.
CAUTION! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
DISPOSING OF TOOL
If your tool has become damaged beyond repair, do not throw it
out. Bring it to the appropriate recycling facility.
16
All manuals and user guides at all-guides.com
For technical questions call 1-800-665-8685
8348690