PRO-POINT 8348690 Mode D'emploi page 10

V 3.0 1/4 in. Composite Angled Air Die Grinder
AIR SOURCE INSTALLATION
WARNING! Never use pure oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source for a tool. Such gases
are capable of causing an explosion and serious injury to persons.
1. Set the air pressure regulator on the air compressor to the
recommended PSI level (see Specifications). Do not exceed
the tool recommended air pressure. Excess pressure could
result in damage to the tool, to your workpiece or serious
injury.
2. Prepare a standard 1/4 in. air connector for use with your
tool. Wrap the threaded portion of the air connector with
thread tape. Wrap in a clockwise direction so it will not
unravel when attaching to a quick connector. Attach it to the
tool air inlet and tighten.
3. Attach a standard quick connector to the air source's hose.
Attach the air hose to the tool's air connector.
4. Check the air line and its connections for air leaks. Do not
use the tool until you have repaired all air leaks.
DISCONNECTING AIR SOURCE
WARNING! Failure to follow these steps could result in severe
injury, tool or property damage.
Disconnect tool from air source before cleaning, servicing,
changing parts/accessories or when not in use.
1. Turn hopper regulator to the OFF position.
2. Turn the air regulator to the OFF or L position.
3. Turn off the air compressor.
4. Disconnect the air pressure hose.
5. Discharge any residual pressure inside the tool.
10
All manuals and user guides at all-guides.com
For technical questions call 1-800-665-8685
8348690