PRO-POINT 8348690 Mode D'emploi page 9

8348690 1/4 in. Composite Angled Air Die Grinder
AIR COMPRESSOR
Ensure the compressor
used with the tool can
supply the required
Cubic Feet per Minute
at the required PSI (see
Specifications).
1. Use proper size and
type of air pressure
line and fittings.
2. Use only clean,
dry, regulated
compressed air at
the rated range as
marked on the tool.
CAUTION! Do not use an
air source other than an
air compressor to power
this tool.
3. Always use an air regulator, an in-line filter and a moisture
trap in your compressed air system. These accessories will
increase the tool's life and keeps the tool in good working
condition. See the diagram for recommended components of
an air line.
4. Avoid using an air hose that is too long. The longer the hose,
the lower the pressure that reaches the tool, possibly causing
it to cease functioning. As well, a longer hose can become a
tripping hazard.
5. Air tool CFM consumption ratings are based upon a 25% duty
cycle. If you require continuous duty, a larger compressor is
required.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
V 3.0
9