Publicité
Les langues disponibles
Les langues disponibles
8348690
1/4 in. Composite Angled Air Die Grinder
ASSEMBLY
NOTE: When this manual refers to a part number, it refers to the
included parts list.
INSTALL AIR CONNECTOR
Prepare a standard 1/4 in. NPT male air connector for use with your
tool.
1. Wrap the external threads of the male connector with sealant
tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several open at the
front to attach the tool.
2. Screw the connector into the tool's air inlet and tighten with
a wrench until snug.
3. Run compressor at a low volume and check the connection
for air leaks. Do not use the tool until all air leaks are repaired
or the faulty component is replaced.
OPERATION
INSTALLATION OF ACCESSORIES
1. Select the appropriate accessory for the task. Only use a
stone which is specifically designed for use with the die
grinder. Make sure they are capable of handling the tool's
maximum speed of 22,000 RPM. Make sure the accessory is
tightly installed.
2. Attach the accessory to the grinder.
a.
Push the spanner in the collet shaft.
b.
Insert mandrel into collet chuck a minimum of 1/4 in.
to prevent wheel or file from disengaging with grinder
while in use.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
V 3.0
13
Publicité
