Publicité
Les langues disponibles
Les langues disponibles
8348690
1/4 in. Composite Angled Air Die Grinder
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts,
contact Princess Auto Ltd. for a solution. If unable to do so, have a
qualified technician service the tool.
Problem(s)
Tool runs at
normal speed
but loses
power under
load.
Tool runs
slowly. Air
flows slightly
from exhaust.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
Possible cause(s)
Motor parts worn.
Lack of air tool oil. Pour air tool oil into air inlet
Motor parts
jammed with dirt
particles.
OR
Air flow blocked
by dirt.
Excessive air tool
oil in tool.
Build up of
shipping grease.
Air Flow Regulator
is in the closed
position
Suggested solution(s)
Have a qualified technician
replace worn parts.
per instructions.
• Check air inlet filter for
blockage.
• Pour air tool oil into air
inlet as per instructions.
• Operate tool in short
bursts.
• Disconnect air supply.
Free motor by rotating
drive shank manually
where applicable.
• Repeat above as
needed. If this fails,
bring to Princess Auto
Ltd. or to a qualified
technician.
Run tool under no load for
short periods of time until
exhaust clears.
See Removing Packing
Grease section.
Open regulator to correct
position
V 3.0
19
Publicité
