Reely Desert Climber Notice D'emploi page 40

• When the car's drive battery is weak, the car gets slower or no longer responds correctly to the transmit-
ter.
The drive battery in the vehicle is not only used for supplying the engine though the speed controller.
The speed controller also generates the voltage/current required for operating the receiver and the
steering servo.
For this, the speed controller has an integrated BEC ("Battery Eliminator Circuit"; electronic circuit for
direct voltage supply of the receiver without additional receiver battery).
If the voltage in the drive battery is too low, the voltage at the receiver may also drop, causing the vehicle
to no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect drive battery from vehicle
completely, switch off transmitter). Then replace the vehicle drive battery or recharge the drive battery.
Before recharging the rechargeable battery, let it cool off entirely.
• The motor and drive as well as speed controller and drive battery of the vehicle get hot during operation.
Wait at least 5 to 10 minutes before exchanging the rechargeable battery.
• Do not touch the motor, the speed controller or the rechargeable battery until they have cooled down.
Danger of burns!
40