Driving The Vehicle - Reely Desert Climber Notice D'emploi

Buggy électrique 1:10xs 4wd rtr
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- Connect a fully charged drive battery to the speed controller in the correct polarity (red cable = plus/+,
black cable = minus/-).
- Now switch on the speed controller. Wait for a few seconds until the speed controller has completed
its self-test.
- Set the trim controller "ST TRIM" at the transmitter so that the front wheels are roughly centred. An
exact setting of the straight driving alignment is carried out later when driving the vehicle.
- Check that the vehicle reacts to remote control commands as expected (steering and drive) before
taking it from the support and placing it on the ground with its wheels. Do not reach into the drive, and
do not hold the vehicle by its wheels.
d) Driving the Vehicle
• Improper operation can cause serious damage to people and property! Only drive with the model directly
in view.
• Only drive when your ability to react is unimpaired. Tiredness or the influence of alcohol or medication
can cause incorrect responses, just as with real vehicles.
• Please note that this model car must not be driven on public roads, places or streets. Also do not operate
it on private grounds without the owner's permission.
Operate your model in an area where you do nor endanger any persons, animals or objects. Don't drive
towards animals or people!
Before you operate the model on a place specifically designated for that purpose (e.g. model car racing/
rally route, etc.), ask the operator of that location for permission.
• Avoid driving at very low outdoor temperatures. Plastic parts lose elasticity, which may lead to damage
even in a light accident.
• Do not drive in the case of a thunderstorm, under high-voltage power lines or in the proximity of radio
masts.
• Protect the vehicle, drive battery and transmitter from dampness and severe dirt. Do not expose the
remote control to direct sunlight or excessive heat for a long period of time.
• As long as the vehicle is in operation you must always leave the transmitter switched on.
• In case of a fault stop operating your model straight away and remove the cause of malfunction before
you continue to use the model.
• When parking the vehicle, always switch off the vehicle's speed controller first and disconnect the drive
battery from the speed controller completely then. Now you may turn off the transmitter.
• If the batteries (or rechargeable batteries) in the transmitter grow weak, the range reduces and the
vehicle may no longer react to the control commands at the transmitter. In that case, end driving with
the vehicle and switch off the speed controller. Then exchange the batteries or rechargeable batteries
in the transmitter for new ones.
39

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1527213

Table des Matières