Hypertherm Powermax30 Mode D'emploi page 8

Magnetics Assembly Replacement
Remove the plastic base and magnetics
1. On the back of the power board, remove the wires for the transformers and inductors.
a. Remove J13, J14, and J15, located on the front panel end of the power board.
b. Remove J18 and J19, located on the rear panel end of the power board.
c. Remove J20, J21, and J22 located on the bottom center of the power board
J13
J14
J15
J22
2. On the fan side of the power supply, remove the ground wire screw from the base of the magnetics assembly.
8
Figure 9
J20
J21
Figure 10
Powermax30/Powermax30 XP Field Service Bulletin 805320
J19
Ground wire screw
J18