Hypertherm Powermax30 Mode D'emploi page 4

Magnetics Assembly Replacement
Remove the power supply cover and component barrier
1. Set the power switch to OFF (O), disconnect the power cord from the power source, and disconnect the gas supply.
2. Remove the 2 screws from the handle on the top of the power supply.
3. Slightly tip the front and rear panels away from the power supply so that you can get the edges of the handle out from
underneath them. Remove the handle, and set it and the 2 screws aside.
4. Continue to tilt the panels outward to release the fan side of the cover from its track. Then lift the cover off the power
supply.
5. Remove the component barrier from the power board side of the power supply. The barrier is flexible and can be bent
slightly for removal.
4
Figure 1
Figure 2
Powermax30/Powermax30 XP Field Service Bulletin 805320
Component barrier