IPC Gansow 1010 S Manuel D'instructions page 26

7.9 - REPLACING THE FLAPS
Fixed side and rear flaps: loosen the screws that secure the flap
retainer to the machine's chassis.
- Remove the flap retainer.
- Replace the flap with a new one.
- Put the flap retainer back in place and fasten the screws you
previously removed.
Adjustable front flap: release the clip fastening the flap lifting cable.
- Remove the flap retainer.
- Replace the flap with a new one.
- Put the flap retainer back in place and fasten the screws you
previously removed.
- Fasten the flap lifting cable to the flap.
7.10 REPLACING AND REGULATING
THE BRAKE CABLE
To replace the brake cable:
-Loosen the machine nose fixing screws and remove the nose.
-Loosen the bumper fixing screws and remove the bumper.
-Loosen the cable clamp (61) fitted to the brake.-Pull the cable
out of the pedal, making sure not to loose the brake return spring
(60).
Re-assembling:
-Before fitting the cable, loosen the adjustment screws (40).
-After slotting the cable through the cable holder pin (37) located
on the brake pedal, first slot the cable through the centring pin (39),
then through the adjustment screw (40).
-Fit the cable into the sheath (57) and the spring onto the cable.
-Secure the cable in place with the clamp (61).
-Clamp the sheath and cable into the appropriate sheath holding
clamp (55).
-To adjust the braking efficiency, act on the adjustment screws (40)
located near the brake lever.
ENGLISH (Translation of original instructions)
All manuals and user guides at all-guides.com
To replace the flap lifting cable:
-Loosen the machine nose fixing screws and remove the nose.
-Loosen the bumper fixing screws and remove the bumper.
-Loosen the cable clamp (43) fitted to the brake.
-Remove the clip (33) from the flap fork.
-Remove the cable (36).
-After removing the fork and nut (35) from the broken cable (if they
are in good repair), mount
them on the new flap lifting cable.
-Secure the fork to the flap using the clip (33). Put the spring (37)
onto the cable and slot the cable through the guide pin (40). Insert
the cable (36) into the sheath (49) and then slot it through the
centring pin (47). Insert the cable into the cable clamp (45) and
secure it in place with the other clamp (43).
Before carrying out any work on the machine,
make sure that it is off and that all its functions are
disabled. This is done by turning the key switch
5, fig. 3 OFF.
7.11 - REPLACING AND REGULATING
THE FLAP LIFTING CABLE
Reassembling:
Pag. 11