5.1
CONTROLS
1:Brake locking pedal
Pressing it with the service brake, 2, disables the latter and engages
the parking brake. To release the parking brake, press service brake
2 and the brake locking pedal will snap into its rest position.
2:Service brake
Operate this pedal to stop the machine during operation.
3:Flap lifting pedal
Use the pedal when you are tackling bulky but light wastes. Do not
keep the pedal pressed down unless it is strictly necessary.
4:Direction selection pedal.
Use this pedal to select the driving direction.
5:Right side brush control lever
By pulling and pushing down the side brush lever, the brush moves
to work position and starts spinning. At the end of your work, put
the lever back to its initial position.
5-A:Left side brush control lever
As above in the double side brush version.
6:Emergency displacement bypass
Allows the machine to be moved with the engine off.Loosen the
BAYPASS knob 1/2 a round toward 0 MAN to be able to move the
machine with the engine OFF.
7:Centre brush control lever
By pushing the lever back (to ON), the centre brush moves to work
position At the end of your work, push the lever back to OFF.
8:Air intake control lever
Opens or closes the air flow for the sucking of dust.
9:Motor disjoining lever (Clutch)
It stops all the functions relating to the motor during ignition.
ENGLISH (Translation of original instructions)
All manuals and user guides at all-guides.com
Fig.2
Air activating lever. For "cold engine ignition"
Using this lever the rounds of the motor are regulated.
It indicates that the machine is live.
Switches all the functions of the machine on and off.
Press this button to operates the horn.
By means of this butto the filtershaker is operated (see filter
maintenance ch.)
5.2 - INSTRUMENTS DASHBOARD
1:Starter
2:Engine rounds regulating lever
3:Hourcounting timer
This indicates the total number of hours the machine has worked.
4:Tension gauge.
5:Ignition key.
6:Button to operate the horn.
7:Button to operate the filtershaker
Fig.3
Pag. 5