IPC Gansow 1010 S Manuel D'instructions page 25

After loosening the screws that keep the top right casing and
bottom right casing in place:
BELT 2:
the pulley race and change it.
BELT 4:
the pulley race and change it.
ATTENTION: In order to take the belt 4 it is necessary to take the
belt 2 out first.
BELT 6: Unscrew the 2 blocking screw and slip pulley 5 and 6
fom the proper shafts.
ATTENTION: In order to take the belt 6 it is necessary to take the
belt 4 and 8 out first.
BELT 8: Using a screw driver as a fulcrum, get the belt out of the
pulley race and change it.
BELT 15/1: ( Single side brush version) Using a screw driver as a
fulcrum, get the belt out of the pulley race and change it.
BELT 15/2 - BELT 16: ( Double side brush version)
After removing the snap rings which secure the shaft and pulleys
in place, pull the shaft outwards until it is no longer possible remove
the belt. After replacing the belt, put shaft back and fix it using the
appropriate snap rings.
ENGLISH (Translation of original instructions)
All manuals and user guides at all-guides.com
7.8 - Replacing the belts
Before carrying out any work on the machine,make
sure that it is off and that all its functions aredisabled.
This is done by turning the key switch (5, fig. 3)
OFF.
Using a screwdriver as a fulcrum, get the belt out of
Using a screwdriver as a fulcrum, get the belt out of
Pag. 10