IPC Gansow 1010 S Manuel D'instructions page 21

6.1 - STARTING UP
- Seat on the seat
- Take the accelerator lever 2 Fig. 3 on the START position.
- Pull the starter lever 1 Fig.3.
- Bring the clutch lever 9 Fig.2 in 1-START POSITION and keep it
in this position while activating the key switch 5 Fig.3.
Take the ignition switch on the start position and keep it there until
the motor starts.
N.B. Do not use the starter for more than 5 seconds at once.Shouldn't
the motor start, let the key go and wait for 10 sec.more or less before
using the starter again.At the starting of the engine, bring the
keyswitch on the ON position.
As soon as the engine starts, release the clutch lever9 Fig.2
Acting on the direction-selecting pedal 4 Fig.2 the machine starts
moving.
Pressing the pedal on the RIGHT side, the machine will move
FORWARD.
Pressing the pedal on the LEFT side, the machine will move
BACKWARD.
IMPORTANT: when you have finished yuor work,make sure the
centre brush and side brush are OFF and lifted from the floor,the
parking brake is engaged an the start key removed.
6.2 OPERATIONS
After having started the machine following the instructions of the
previous paragraph, go on as described according to one's needs,
lower the central brush bringing the proper lever 7 Fig.2 in ON
position.
Lower, if necessary the side brush (or both in the double side brush
version) acting on the control levers 5-5A Fig.2.
Should the brushes raise some dust during the work, it is advisable
to turn the sucking on by means of the lever 8 Fig.2
If some bulky and light items are to be picked up, act on the flaplifting
pedal 3 Fig.2. Keep the pedal pressed down just for the time
necessary to do this operation.
In order to have always the maximum from the machine, it is necessary
the same to be always in perfect conditions in order also to guarantee
also the maximum security.
To achieve this, it is necessary to follow carefully all the operations
described in the Maintenance paragraph.
To turn the machine OFF bring the lever 2 Fig.3 in the min. pos. and
turn the key 5 Fig.3 on OFF.It is advisable, always to work with the
highest number of rpm. (lever 2 Fig.3)
In the case the machine moves even if the direction selectionpedal
isn't pressed down, adjust the movement dead point asshown in
paragraph 7.5.
ENGLISH (Translation of original instructions)
All manuals and user guides at all-guides.com
6.3 - Cleaning the rear waste bin.
To empty the rear waste bin operate as follows:
- Release the bin lock.
- Pull out the rear bin by grasping it by the appropriate handles.
- With the help of the wheels fitted to the bin, drag it to the waste
disposal area.
- Empty the contents taking care not to damage the bin.
- Put the bin back into the machine.
- Fasten the lock again.
- N.B. If the bin is full it will be rather heavy to handle.
Therefore it is wise to entrust this operation to two
operators.
ATTENTION: Wastes must be disposed of in accordance
to the regulations in force.
Pag. 6