Publicité
Les langues disponibles
Les langues disponibles
Press " stop
" button (44) at USB stop mode to cancel all programmed memory.
Press the " folder / pre-up " button (44) to select the 1
selection.
The programming model will automatically stop if no button is being pressed in a period of about 10 seconds after
pressing the " mem/clk-adj " button (44).
Listing to tape
General operation
Select the function button (26) to select Tape mode. The LCD display (3) will show " TAPE "
Cassette playback
Stop and ejection
Fast forward
Remark
-
Make sure the direction is correct when inserting the tape into the system.
-
There is some searching noise can be heard and the system cannot perform normal playback function during fast
forward mode.
-
This is recommended to take out the cassette tape from the system every times after listening and don't leave the
cassette tape inside the system when not under playback mode.
Phono Operation
Remove the stylus protector.
-
-
Be sure that the tone arm is being detached from the tone arm rest before operating and
re-secured again afterwards.
1.
Select the Function button (5/45) to " Source " position. The LCD display (3) will show
" PHONO"
2.
Set the speed selector (29) to the proper position depending on the record to be played.
3.
Place the record on the platter (use the spindle adaptor if required).
4.
Set the cueing lever (30) to the up position.
5.
Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate and position the tone
arm over the desired position of the record.
6.
Pull down the cueing lever (30). The tone arm will come slowly on the recorder and start playback.
7.
At the end of record, the tone arm will return to the rest position automatically.
8.
To stop manually, lift the tone arm from the record and return it to the rest.
Play suspension
Set the cueing lever (30) to the up position will life up the tone arm and then stop playback temporarily.
Remark :
- Due to the auto return system was mechanical design and reset point will affected after transportation.
Thus, the tone arm will return to the rest automatically when first time place the tone arm to the platter
and it was not the malfunction.
- Due to the length of the record is various, if you find the tone arm cannot return automatically after
playback the record. Please press the eject button and return the tone arm back to the rest position
- Users should not change to a magnetic cartridge system, otherwise unit cannot be connected anymore
to an aux-in of music-centre
: The system will start the playback automatically after inserting
of cassette tape
: Press the " Tape forward / Eject " button completely inwards
and the cassette tape will be ejected though the cassette door cover. The " Tape forward /
Eject " button will keeping at lowest height position.
: Press the " Tape forward / Eject " button half inwards during
Playback mode, the tape winding forward direction. The " Tape forward / Eject " button will
keeping at middle height position.
Slightly press the " Tape forward / Eject " button again to resume normal playback. The " Tape
forward / Eject " button will resume to the highest position.
st
track of next folder directly and hence to speed up the song
EN-7
Publicité
