Publicité
Les langues disponibles
Les langues disponibles
Installation of counter weight
1.
Slide in the counter weight completely into the rear of the tone arm until it reach the end, turn it clockwise until it click with
pit inside.
2.
Twist the counter weight clockwise & backward until it reach the white line as figure 2
3.
Twist the counter marking until it reach " 1 " position
4.
Twist the counter weight anti-clockwise & inward until it reach the appropriate working pressure.
Remark : The working pressure of the provided stylus is from the range 4 – 6 grams. According to the cartridge manufacturer.
All stylus has it own working pressure and please refer to the specification respectively.
Connection
1.
Connect the AC line cord (34) to AC outlet.
2.
Press the On/off button (4/35) and if standby LED indicator (2) light off, it's mean the power supply is normal. Now your
system is ready to play the music.
Setting the clock
1.
Set unit in standby mode.
2.
Press & hold the " MEM/CLK-ADJ " button (44), the LCD display (3) will show " 24 hr "press TUNE
button (16/44) to select the appropriate area hour format (12hr/24hr). Press "MEM/CLK-ADJ" button (44) again to
confirm.
3.
The LCD (2) will display the first & second digit of " 00 " is flashing. Press TUNE
the correct hour. Press " MEM/CLK-ADJ " button (44) to store the correct hour.
4.
The third & fourth digit of " 00 " is flashing, press the TUNE
Then press " MEM/CLK-ADJ " to store the correct minute.
The pre-set time will be re-set completely if dis-connecting the main power supply. You are
recommended to switch the system into standby mode for convenience usage.
Listening to radio
Manual tuning
1. Press the On/off button (4/35) to switch on the unit and press the function switch (5/45) to select " Tuner " mode.
2. Press and hold the TUNE
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2 & 3 until the desired radio station is being reached.
5. Adjust volume up/down button (9/42) to the desired volume level.
Preset stations
You can store up to total of 30 radio stations in the memory.
1.
Set to " Tuner " mode
2.
Turn to the desired radio station by "manual" or "auto" tuning method.
3.
Press " MEM/CLK-ADJ " button (44) to enable program state.
4.
Press "
FOLDER/PRE (44) or FOLDER/PRE
5.
Press " MEM/CLK-ADJ " button (44) again to confirm the setting.
6.
Repeat step 2 to 5 to store other stations.
7.
Press
FOLDER/PRE (44) or FOLDER/PRE
THE PRE-SET MEMORIES WILL BE CANCELLED COMPLETELY IF SWITCHING OFF THE MAIN POWER
BUTTON ON SYSTEM. YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY MODE FOR
CONVENIENCE USAGE.
YOU CAN OVERWRITE A PRESET STATION BY STORING ANOTHER FREQUENCY IN ITS PLACE.
FM & FM-stereo reception
System defaulted in stereo mode. The FM-stereo icon "ST" will light up on LCD display (3) show FM stereo program is
receiving. In particular when stereo signal are weak. It is preferable to receive the program in mono by ST/MP button on
remote control.
Hints for best reception:-
-
FM : The receiver has a built-in FM wire antenna (33) hanging at the rear cabinet. This wire should be totally unraveled
and extended for best reception.
or TUNE
button (16/44) for 1-2 seconds and then release
button to select the desired station memory position for storage.
button at remote handset to select the preset stations in order.
or TUNE
button (16/44) to set the correct minutes.
EN-2
or TUNE
or TUNE
button (16/45) to set
Publicité
