Publicité
Les langues disponibles
Les langues disponibles
CONNECTING A HUNTER SOLAR SYNC
Water Adjustment
The Water Adjustment is a 1 to 10 scale that allows for easy adjustment
of the Seasonal Adjust value from the Solar Sync ET Sensor. Upon
installation of the Solar Sync ET Sensor, it is recommended that the
Water Adjustment setting stay at the default value of 5. However, after
installation, if you find that the seasonal adjust value is lower or higher
than expected, the Water Adjustment value can be modified to modify
the Seasonal Adjust output value. See Calibration/Setup on page 15 for
explanation of how to use Water Adjustment scale to fine tune seasonal
adjust output value.
NOTE: If an individual zone is "wetter" or "drier" than
the rest of the system, simply increase or
decrease the amount of run time on the controller.
14
ET SENSOR
®
Uninstalling a Solar Sync
If a Solar Sync sensor has been installed on the X-Core
the seasonal adjust value used by the controller will be calculated from
the weather data supplied by the Solar Sync sensor. If it is decided that
the Solar Sync sensor will no longer be used with the X-Core controller,
it must be uninstalled. If the Solar Sync sensor is not uninstalled, the
controller will not allow the seasonal adjust value to be manually
changed. For example, if the seasonal adjust value shown on the
controller was 50% when the Solar Sync sensor was removed, it will
remain 50% until the Solar Sync sensor is uninstalled.
To uninstall the Solar Sync sensor, simply disconnect the green and
black wires from the controller terminal and then turn the dial to
the "Solar Sync Settings" position. The display should show dashes,
indicating that the controller no longer recognizes the Solar Sync sensor
for calculation of seasonal adjustment. Now the seasonal adjust value
can be changed manually by turning the knob to the "Seasonal Adjust"
position and using the
Sensor
®
or
button to adjust the value.
controller then
®
Publicité
