Publicité
Les langues disponibles
Les langues disponibles
PROGRAMMING THE CONTROLLER
Manually Run a Single Station
1. Turn dial to MANUAL – ONE STATION position.
2. Station run time will flash in
the display. Use the
button
to move to the desired station.
You may use the
or
to select the amount of time for
a station to water.
3. Turn the dial clockwise to the RUN position to run the station (only
the designated station will water, then the controller will return to
automatic mode with no change to the previously set program).
Also see One Touch Manual Start and Advance.
22
1
MANUAL-ONE STATION
button
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the
2. This feature automatically defaults to program A. You can select
program B or C by pressing the
1
3. The station number will be flashing. Press the
through the stations and use the
times. (If no buttons are pressed for a few seconds during step 2 or 3,
the controller will automatically begin watering).
4. Press the
a 2 second pause, the program will begin. At any time during the
manual cycle, you can use the
tion to station manually.
button for 2 seconds.
button.
or
button scroll to the station you wish to begin with. After
or
buttons to navigate from sta-
button to scroll
button to adjust station run
Publicité
