TECO 36 TOP Manuel D'instructions page 97

The TPMS device (optional accessory) can be used to check the proper opera-
tion of pressure sensor.
Remove the old weights from the rim before starting work operations.
9.3. BEAD BREAKING
Before bead breaking operation, completely close the turntable (locking wedges
towards the centre) (A, Fig.14), keeping your hands away from moving parts.
A
- Press pedal
figuration, the jaws are completely closed. (Fig. 14).
- Remove the internal valve to fully deflate the tyre (Fig. 14b).
- Adjust the rim rest depending on wheel diameter
-Adjust the inclination of the blade according to the
wheel width by means of the pin in order to obtain a
better inclination between the blade and the tyre: in
position 1 (fig.15) for low width tyres, in position 2 (fig.
15) for high width tyres
-Place the wheel as shown in fig. 16 and take the
blade near the bead, keeping the necessary safety
distance between the rim and the bead breaker blade,
so that the latter works on the tyre and not on the rim.
User's manual
WARNING
WARNING
WARNING
14a
and bring it into completely lowered configuration. In this con-
1
A
2
A
EN
14b
15
97