TECO 36 TOP Manuel D'instructions page 114

9.7.c. SPECIAL PROCEDURE (TI VERSION)
The TI version facilitates bead insertion and inflation of Tubeless tyres through the emis-
sion of a strong jet of air from the nozzles placed near the locking wedges.
Before starting with the operations described below, make sure there is no
dirt, dust or other impurities near the inflation nozzles. It is advisable to wear
protective goggles.
- Verify that both upper and lower tyre beads and rim bead seat have been properly lu-
bricated with an approved mounting paste. Move the horizontal arm to the wheel centre
(all slipped off towards the operator)
- Make sure that the wheel is clamped to the turntable from the inner side (fig.40).
- Lower the vertical arm until it touches the rim (fig.36), then clamp the arm in this position.
- Remove the valve core if it has not already been removed (Fig. 37).
- Connect the Doyfe connector of the inflating hose to the valve stem (Fig. 38).
- Fully press the inflation pedal for a short time (Fig. 41). The tyre will expand, and the
beads will seat.
- Unlock the wheel from the wedges.
- Move the inflation pedal into an intermediate posi-
tion (Fig. 42) to inflate the tyre. Frequently check
that the pressure NEVER exceeds the maximum
pressure indicated by the manufacturer on the tyre.
To increase the effectiveness of the air jets, manually lubricate and lift the lower
bead before activating the nozzles.
114
WARNING
WARNING
41
40
42
User's manual