TECO 36 TOP Manuel D'instructions page 112

This operating phase may involve noise levels of 85 dB (A).
It is therefore suggested that ear protectors be worn.
It is suggested to wear eye protection to prevent injury due to
contact with dusts or any fragments inserted into the tyre.
A bursting tyre can cause projections of its parts in surrounding areas with a
force sufficient to cause serious injury or death.
Do not mount a tyre if its dimensions (indicated on the side) do not correspond
exactly to the rim dimensions (printed inside the rim) or if the rim or the tyre is
defective or damaged.
Never exceed the pressure recommended by the tyre manufacturer.
The tyre changer is not a safety device and does not prevent tyres and rims from
exploding. Keep all persons not working on the machine out of the working area.
9.7.b. TYRE INFLATION
- Make sure the wheel is NOT
clamped on the turntable by the
centring jaws (Fig. 35).
- Move the horizontal arm to the
wheel centre (all slipped off towards
the operator).
- Lower the vertical arm until it
touches the rim (fig.36), then clamp the arm in this position.
- Remove the valve core if it has not already been
removed (Fig. 37).
- Connect the Doyfe connector of the inflating hose
to the valve stem (Fig. 38).
- Inflate the tyre with the appropriate gun or by
pressing the pedal in an intermediate position (Fig.
39). Frequently check the pressure on the pres-
sure gauge to make sure that the pressure NEVER
exceeds the maximum pressure indicated by the
manufacturer on the tyre.
112
WARNING
DANGER
YES
NO
35
36
User's manual