TECO 36 TOP Manuel D'instructions page 108

9.6.c. Lower bead mounting
- Place the bottom bead of the tyre underneath the tool and at the same time apply a lit-
tle pressure to the tyre by hand while starting to rotate the wheel (pedal
easier bead insertion.
- Rotate until tyre mounting is complete (Fig. 32b).
9.6.d. Upper bead positioning
- Position the upper tyre bead.
Take care that the tyre does not slip underneath the tool.
9.6.e. Bead presser roller positioning
- Lower the bead presser roller (control
the rim.
1
9.6.f. Upper bead mounting
- Rotate the wheel using pedal
the tyre bead to keep it inserted in the channel until the bead assembly is successfully
completed (fig. 34a).
For oversized (more than 19'') or particularly tough wheels, it is recommended
the use of the pneumatic bead presser. In this case the following procedure
must be applied
108
WARNING
2
33a
to start mounting the upper bead. Press manually
NOTICE
) (A) until it is level with the well of
) for
33b
User's manual