Charging - SilverCrest SRRK 3.7 A1 Mode D'emploi

5. Charging

WARNING! Risk of material damage!
The battery must only be charged using the plug-in power
unit 15 supplied. Charging the battery via other devices is
not permitted. The devices could be damaged.
NOTES:
• Before the device is used for the first time, and during the fol-
lowing three charging procedures, the device should be
charged for 90 minutes in each case.
• When the battery is almost flat, the red battery symbol 14
flashes red. The device can then only be used for a short time
without being connected to the electricity supply.
• It takes about 5 minutes to charge the device sufficiently for
one shave.
• When the battery is fully charged, the device can be used
for approximately 60 minutes without being connected to the
power supply.
1. Switch off the device with the on/off switch 13 if necessary.
2. Insert the small plug of the plug-in power unit 15 into the
connecting socket 7 of the shaver 12.
3. Plug the plug-in power unit 15 into an easily accessible wall
socket, the voltage of which corresponds to the rating plate of
the plug-in power unit. The wall socket must continue to be
easily accessible after the device is plugged in.
4. The battery symbol 14 will be lit red and the battery will be-
gin charging. When the battery is fully charged, the battery
symbol flashes blue. When the battery is fully charged, the
device can be used for approx. 60 minutes without being
connected to the power supply.
11
GB