Charging The Appliance; Tips And Tricks - SilverCrest SBT 3.6 B1 Mode D'emploi

CAUTION – PROPERTY DAMAGE!
Only use the appliance in an enclosed space.
►
Do not dispose of the battery unless it is completely
►
discharged. If the battery is not discharged when you
dispose of it, cover the poles with sticky tape.

Charging the appliance

1) Insert the connector plug of the mains adapter cable
on the hand element
2) Connect the mains adapter
to indicate that the appliance is charging.
As soon as the control lamp
can disconnect it from the mains power supply.
NOTE
► The appliance needs around 12 hours to fully charge the first time. Always stop
charging as soon as the control lamp
► When the appliance is fully charged, you can shave and trim for about 60 minutes
or epilate for around 30 minutes.
► Do not recharge the appliance until the control lamp
red and green (indicating low battery charge level).

Tips and tricks

NOTE
► Do not use the appliance if...
― You have sunburn on the specific part of the body.
― You have skin irritation or redness.
― You have a skin disease such as neurodermatitis.
― You have pimples, moles or warts on the affected parts of the body.
― You have wounds, open sores or raised scars on the affected parts of the
body.
► First test the appliance on a small hidden location to establish the skin compatibility.
■ The hairs to be epilated should be between 0.3 cm and 0.5 cm long. Shorter hairs
are not gripped by the tweezers and plucking out longer hairs is very painful.
Shorten longer hairs, if required.
■ The skin must be free of grease or cream residues. Otherwise, the tweezers will
stick/soil and the efficiency of the appliance will be reduced.
■ The skin must be completely dry.
■ The best time for epilation is in the evening after a shower. Then the skin is somewhat
softened, so that the hairs can be plucked out easily. In addition, the skin can recover
overnight, and any skin reddening will recede.
SBT 3.6 B1
.
to a power socket. The control lamp
lights up green the appliance is fully charged and you
lights up green.
into the connection socket
lights up red
starts alternately flashing
│
GB 55 ■