EUROM Alutherm Verre Wi-Fi 1000 Mode D'emploi page 40

3. Open the Eurom Smart App.
4. Add the Wi-Fi thermostat and other devices to the Eurom Smart App.
5. Go to the device(s) and press the Pairing Button to pair the device(s) to
the Wi-Fi thermostat.
The device is connected to the Wi-Fi thermostat. The G-sign illuminates in the Eurom Smart
App and on the device. Now you can enjoy the optimized comfort level of permanent electric
heating.
After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 17, pos. 1).
2. Disconnect the power plug from the power outlet (Figure 17).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control (Figure 18).
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug are damaged, they should be replaced by the
manufacturer, their service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
This device becomes very hot. Make sure the device is turned off, unplugged
and completely cooled down before cleaning it.
CAUTION
Do not use:
•
•
•
Prevent water from entering the device. Do not immerse any part of the device
in water or other liquids.
It is recommended to clean the device after each use and prior to storage.
1. Carefully vacuum the openings to remove dust and dirt.
40
scouring pads;
hard brushes;
flammable, aggressive or chemical cleaning products.