EUROM Alutherm Verre Wi-Fi 1000 Mode D'emploi page 32

4. Drill two holes at least 610 mm above the
floor for the brackets. The distance between
the holes is approximately
(Figure 10, pos. A)*:
•
Alutherm 1000 Verre Wi-Fi: 255 mm;
•
Alutherm 1500 Verre Wi-Fi: 400 mm;
•
Alutherm 2000 Verre Wi-Fi: 563 mm.
5. Place wall plugs (Figure 10, pos. 2).
6. Screw and tighten a left and a right bracket
(Figure 10, pos. 3) to the wall with a large
screw (Figure 10, pos. 4) using a Phillips
screwdriver (Figure 10, pos. 1).
* CAUTION
Be aware that these are the holes for the wall bracket and not the slots in the
heater.
7. Lay the device down on a soft, steady surface
(Figure 11, pos. 4).
8. Screw and tighten two brackets
(Figure 11, pos. 1) on both sides of the main
body (Figure 11, pos. 5) with a small screw
(Figure 11, pos. 2) using a Phillips screwdriver
(Figure 11, pos. 3).
32
Figure 10
Figure 11