EUROM Alutherm Verre Wi-Fi 1000 Mode D'emploi page 35

Temperature sensor (Optional)
CAUTION
For accurate temperature measuring use the external temperature sensor.
1. Make sure the ON/OFF switch is in the OFF
position (Figure 16, pos. 2).
2. Connect the temperature sensor connector
to the sensor plug (Figure 16, pos. 1).
3. Place the temperature sensor approximately
2 meters away from the device.
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
CAUTION
When the device is turned on or off, it may emit a sound. This is caused by
material expanding and shrinking during heating and cooling down.
CAUTION
The day and time settings will be lost if the device is switched off by using the
ON/OFF switch or by unplugging it.
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged;
the device is not covered or blocked;
the device is securely installed.
Figure 16
35