EUROM Alutherm Verre Wi-Fi 1000 Mode D'emploi page 34

Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted or stands in the right place.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 1200 Watt (1000 Verre),
1800 Watt (1500 Verre) or 2500 Watt (2000 Verre). Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Make sure the device is correctly assembled.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 14, pos. 1).
3. Place the power plug (Figure 14, pos. 2) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 2500 Watt.
Remote control
1. Remove the battery cover (Figure 15, pos. 1).
2. Insert two AAA 1.5V batteries
(Figure 15, pos. 2) in the battery
compartment. Make sure to insert the
batteries correctly.
3. Replace the cover.
34
Figure 14
Figure 15