Publicité
Les langues disponibles
Les langues disponibles
1.
Set the ON/OFF switch to the ON position
(Figure 17, pos. 1).
2.
The display (Figure 17, pos. 2) will show OFF.
3.
Press the ON/OFF button.
4.
Press and hold the SET button until SET
appears on the screen.
5.
Use the plus and minus buttons to select the
correct day and confirm with the SET button.
6.
Use the plus and minus buttons to set the
correct time:
•
Hours, confirm with the SET button;
•
Minutes, confirm with the SET button.
7.
Press the MOD button to choose the desired
function: manual or program.
Manual function
1.
Set the capacity at which the heater will work using the plus and minus buttons. The
3 suns indicate whether the heater is set to low, medium or high capacity.
Program function
1.
Set the desired temperature for the device using the plus and minus buttons. The device
automatically chooses the correct heating capacity to achieve and maintain the desired
temperature;
•
10 minutes after the desired temperature has been reached the device will change from
high capacity to medium capacity;
•
every 5 minutes the device will check the ambient temperature and adjust the heating
capacity:
-
if the ambient temperature is more than 1 degree below the desired temperature,
the device will increase capacity;
-
if the ambient temperature is within 1 degree below and 1 degree above the
desired temperature, the device will maintain current capacity;
-
if the ambient temperature is more than 1 degrees above the desired temperature,
the device will decrease capacity;
-
if the ambient temperature is more than 2 degrees above the desired temperature,
the device will stop heating after 5 minutes.
In most cases the device will heat up the room to a slightly higher temperature than the
desired one. To save energy, it is recommended not to set the desired temperature too high
and adjust accordingly.
Weekly timer setting
The week timer can be set via the remote control or the control panel, but it is easier to use
the Eurom Smart App.
1.
Make sure the device is set to program function.
2.
Press and hold the WEEK button until '01' or '][' starts to blink on the screen.
3.
Use the plus and minus buttons to choose the desired setting:
36
Figure 17
Publicité
